Paste the last thing you copied.

[AndrewTX]

3200-20MS0-SLDB-SS

[AndrewTX]

15,000 PSI Pressure Transducer with 1502 Connection for Fluid End

[AndrewTX]

   Information Provided                        
                           
      Est. Min. inlet Press is 60 psig based on experience in similar application                     
      NOTE : Cranking Ratio and time to start are ASSUMPTIONS ONLY and DO NOT Account for Parasytic Loads                     
                           
                           
   VR =   (Ns)   (Ts)   (Vs)    (Patm)            
       (Vp) -     (Sp + Pipe Loss)                  
                           
   VR =   6   15   25.46   14.7   ="   33683.58      
         150   60   10      80      
                           
WHERE:                        Value   Units
VR =    Volume of Receiver (Cubic Feet)                     421.04   Cf
Ns =    Number of Start Starts desired                     6   30
Ts =    Time for 1 start Attempt                     15    Seconds
Vs =    Volume Consumed in second @ Sp (SCFS)                     25.46   Scfs
Patm =    Atmospheric Pressure, Psia (Psig + Patm)                     14.7   psi
Vp =    Beginning Pressure in Receiver, Psia (Psig + Patm)                     150   psia
Sp =    Minimum "Dynamic" psig required                     60   psia
   @ starter inlet to crank engine                        
Pipe Loss =    Estimate line loss in piping. (20 psig default)                     10   psia
                           
   To Convert Cubic Feet to U.S. Gallons